Back Maintenance HVAC, Plumbing Recommendations Reduce Emergencies

Your water heater is one of the used and higher priced appliances in your home, and consumes a large associated with your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving around the home heating and energy costs.

Regular flushing of the water heater are probably the single most important step you get to prolong its service life and even save energy. Over a period of time, sediments build up in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not only destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most regions of the country, the common water heater lasts 3-5 years. Regularly flushing your hot water heater can double the life of your water heater from 3-5 to 7-10 years. And with the costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is a must in today’s markets. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs in half. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a week.

To drain your water heater, first you should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it can be an electric heater). Failure to do so could result in overheating and severe damage to the water heater. Next, close the water supply valve located on a water inlet line going into your water heater. You may then connect a hose to the drain valve located towards the end of the hot water heater. Open the drain and allow it to move until all on the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until the water flows out perfectly. This will allow air to vent off of the heater and the water lines. Finally, you can turn the thermostat in order to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas possess hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in region to discuss options and merchandise to fit the bill.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2